Multibond Hi Temp RTV Silicone Gasket Maker for timing cover oil pans,water pump

Description

Multibond Hi Temp RTV Silicone Gasket Maker for timing cover oil pans,water pump
FOR TIMING COVER,OIL PANS, INTAKE MANIFOLDS AND WATER PUMPS,ENGINE BLOCKS, DRIES SECURELY AS GASKET
HIGH TEMPERATURE RESISTANT 650F
RESISTS CRACKING, SHIRKING AND MIGRATING CAUSED BY THERMAL CYCLING
PRODUCT BENEFITS
• High temperature use
• Superior adhesion and flexibility
• Replaces most cut gaskets
• Can be used as a gasket maker or dressing
• Easy application
• Non-flammable
• Non-toxic
DIRECTIONS FOR USE
For assembly as a form-in-place gasket
1. Remove all previous material from mating surfaces. Permatex Gasket Remover is recommended for most materials, not for plastics or painted surfaces.
2. For best results, clean and dry all surfaces with a residue-free solvent, such as Permatex Brake and Parts Cleaner.
3. Cut nozzle to desired bead size, 1/16“ to 1/4“ in diameter. An 1/8” bead is usually sufficient for most applications.
4. Remove cap, puncture tube or cartridge seal and attach extension nozzle.
5. Apply a continuous and even bead of silicone to one surface, first tracing the internal areas of the gasket configuration, then all surrounding bolt holes as shown up:
6. Assemble parts immediately while silicone is still wet.
7. Finger tighten flange only until material begins to seep out the sides of the flange.
8. Allow to set for at least two hours and re-torque at lease one quarter to one half turn.
9. For best results, allow to cure overnight.
For assembly as a gasket dressing
1. Repeat steps 1 thru 4 as in previous section.
2. Apply a thin film of silicone to one surface to be sealed.
3. Place the pre-cut gasket onto silicone film.
4. Apply a second thin to pre-cut gasket surface.
5. Remove any excess and assemble parts immediately. Note: Product not recommended for use as a cylinder head gasket or head gasket sealant.
Instructions for PowerBead
1. Clean and dry all flange surfaces to be sealed.
2. Remove black cap from top of extension nozzle.
3. Turn nozzle extension one complete turn (360°) counterclockwise.
4. Depress finger trigger and apply a continuous 1/16 inch to 1/8 inch PowerBead to one surface.
5. Assemble parts immediately while silicone is still wet.
6. Finger tighten flange only until material begins to seep out the sides of the flange.
7. Allow to set for at least two hours and re-torque at least one quarter to one half turn.
8. For best results, allow to cure overnight.
9. To close, turn extension nozzle clockwise until tight (about one full turn). Wipe off excess material from nozzle and replace black cap.
Chemical / Solvent Resistance
The product retains effective properties in contact with automotive fluids, such as motor oil, transmission fluids, alcohol and antifreeze solutions. Note: Not recommended for
parts in contact with gasoline.