KICKER DX350 AMPLIFIER MONO, MADE IN USA,SWX, REMOTE gain, end caps, NEW IN BOX!

Description

1 brand new in the box, never opened, Vintage DX350 amplifier!
all the goodies in the box.   end caps, manual, emblem, a new swx with all the chips, a 20 ft remote gain cord and the coolest old school steel Gain with the rubberized knob that KICKER ever produced.
This amp is brand new and never opened, just like you went back in Time and bought it the shop.
The amp is in the box in the pictures, the other items in picturess are to show you what else is in the box.
You will get:
DX350 amp , brand new in teh box, never even been in aa store, it;s straight from teh factory in stillwater Oklahoma.
SWX with the full set of Chips.  60Hz 80Hz and 100Hz.
The remote Gain and 20 foot cord  as shown in the pics.
end caps included so the amp will look just like the one in the pics,
Also the emblem type shown.
Key Features:
Class D circuitry
frequency response 10-200 Hz
175 watts x 1 at 4 ohms
350 watts x 1 at 2 ohms
requires 8-gauge power and ground leads — wiring and hardware not included with amplifier
MOSFET power supply
module docking port with two-way active crossover (can be set for high- or low-pass at 60, 80, or 100 Hz, 24 dB/octave)
preamp outputs can pass a full-range signal or be set for high- or low-pass at 60, 80, or 100 Hz, 24 dB/octave
oversized power connectors
remote gain controller
12-5/16"W x 3"H x 10-1/16"D
Features Detailed
Class D amplifier: The high-efficiency Class D power supplied in the
K
ICKER
DX amps lets you squeeze the absolute maximum out of your charging system. Unlike inefficient standard amps that operate at around 50-60% efficiency at full power and an even lower 30% at one-fourth power
DX amps operate at an incredible 70-80% efficiency across the entire power range.
Line Output:
The gold-plated RCA outputs on this amplifier are able to send a signal to a second amplifier. They can send a low-pass, high-pass, or full-range signal using the included crossover.
Speaker Output:
There are two +/- pair of terminals, but they are connected together internally and they provide mono output. If two 4-ohm speakers are connected, one to each set of terminals, the amplifier will see a 2-ohm load, because the terminals are internally wired in parallel.
Protection Circuitry:
Reverse polarity, Thermal, short circuit, and over voltage circuits are used to help protect the amplifier from damage and ensure reliable operation.
LED Condition Indicators:
A red power LED and a yellow protection LED are used to report the amp's operating status.
Controls
Right Side of Amplifier:
Input Gain Control:
the gain control is variable from 150mV to 3V
Subsonic Filter Switch:
the subsonic filter engages at 25Hz and has a slope of 24 dB/octave. It can be turned on or off.
Remote Gain Control Jack:
phone type jack, The remote control is 1.275" tall, 2.158" wide, and 2.122" deep (3.054" including the knob). This replacement board does not come with a a remote gain knob. Pics are actual.
Inputs and Outputs
Right Side of Amplifier:
Line In Connections:
two gold-plated RCA jacks
Line Out Connections:
two gold-plated RCA jacks
Remote Gain Control Jack:
phone-type jack
Docking Port:
for crossover module
Speakers Outputs:
two pair of gold-plated set screw terminals; direct input up to 8 gauge wire. These two sets of terminals are internally wired in parallel.
Left Side of Amplifier:
+12V:
gold-plated set screw terminals; direct input up to 8 gauge wire
Ground:
gold-plated set screw terminals; direct input up to 8 gauge wire
Remote Turn-On Lead:
gold-plated set screw terminals; direct input up to 8 gauge wire
Specifications
Under Rated these amps and all KICKER amps will have a greater Output than these basic specs. 450 to 500 + watts is not uncommon for the DX350/ Birth sheet is in the unopened Box. these are brand new and never opened.
Power Output (at 14.4 volts):
175 watts at 4 ohms
350 watts at 2 ohms
Signal-to-Noise Ratio (S/N): 100dB
Total Harmonic Distortion (THD):
less than 0.3% at 4 ohms
less than 0.6% at 2 ohms
Best Frequency Response: 10Hz to 200Hz (+/-2dB)
Input Sensitivity: 150mV-3V
Input Impedance: 22 k Ohms
Fuse Rating and Type: two 25-amp blade fuses
This can go International though eBays Global shipping program.
This is a brand new in the box Vintage amplifier in perfect working order , the DX line has plenty of Fans around the world having only two amps in the line DX350 and DX700 both being Mono Class D and matching the ZR line. Be sure this amp is what you want because there is no returns, it's as awesome as I described and an extreme rare find.
Tracking and insurance will be provided.