-40%

Hifonics GA-5000.1D GOLIATH 5000 Watt Mono 1-Ohm Stable Amplifier HIGH END POWER

$ 512.82

Availability: 34 in stock
  • Condition: New
  • Brand: HiFonics
  • Amplifier Type: Mono
  • Number Of Channels: 1
  • Manufacturer Part Number: GA5000.1D
  • Return shipping will be paid by: Buyer
  • Restocking Fee: No
  • Item must be returned within: 30 Days
  • Returns Accepted: Returns Accepted
  • Refund will be given as: Money Back

    Description

    Description
    Hifonics GOLIATH 5000 watt Super D-Class™ 1 ohm stable mono subwoofer amplifier designed with Ultra-Fi MOSFET output devices and 4 way system protecion cicutry. The GA-5000.1D is a strapple amplififer. Bass remote included.
    CLASS
    Super D Class™
    VARIABLE VOLTAGE
    9V - 0.2V
    SIGNAL TO NOISE
    >95dB
    FREQUENCY RESPONSE
    10Hz-50KHz
    CROSSOVER
    Variable
    Electronic
    VARIABLE LOW PASS CROSSOVER 12DB PER OCTAVE
    35Hz - 250Hz
    BASS BOOST
    0 - 10dB
    SUBSONIC FILTER
    15Hz - 35Hz
    PHASE SHIFT
    0-180°
    POWER @ 1 OHM
    1 x 5000
    POWER @ 2 OHMS
    1 x 2500 Watts
    POWER @ 4 OHMS
    1 x 1250 Watts
    MONO BRIDGED @ 4 OHMS
    N/A
    TOTAL CHANNELS
    1
    AUDIO INPUTS
    RCA
    AUDIO OUTPUTS
    1 RCA Output
    (Master)
    1 RCA Input
    (Slave)
    STRAPPING
    Mode Switch
    MST/SLV
    POWER TERMINAL 12V/GND
    0 AWG
    SPEAKER TERMINAL WIRE GAUGE
    10 AWG
    FUSING
    External 275A
    TOTAL HARMONIC DISTORTION (THD)
    <0.10%
    LOW NOISE PRE-AMPLIFIER CIRCUITRY
    Maximum low voltage signal from the source unit comes into the amplifier circuit with minimal distortion
    RCA INPUTS
    Nickel-plated RCA jacks create the most effiecient audio connection and resist corrosion
    OPERATION MODE
    Mono only
    CROSSOVER TYPE
    Internal crossovers networks allow for audiophile control of equalization circuits
    ELECTRONIC EQUALIZER
    Control of amplifier output with on-board electronic crossover to tailor specific frequencies to speakers and subwoofers.
    Check specifications for specific frequencies for this amplifier
    CLASS / TOPOLOGY
    Super D-Class™ designs which employ high-speed microprocessors with proprietary D/A conversion algorithms to efficiently control the current consumption. At very high listening levels, Hifonics amplifiers with Super D-Class circuitry result in lower distortion, higher current efficiencies and less heat than conventional D-Class amplifier designs
    OUTPUT DEVICE TECHNOLOGY
    The Ultra-Fi™ MOSFET is designed for music production vs just electronics output power. It produces very musical high power with high efficiency for cooling and minimal distortion
    HEAT SINK
    Classic aluminum Hifonics design to minimize heat build up on the Ultra-Fi™ output devices
    POWER SUPPLY
    Simpatico Coil Design
    The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
    OUTPUT CONNECTIONS
    High temperature impact resistant nickel plated connectors with Allen head set screws which allow for secure termination of wire and creates an erosion resistant seal
    CONNECTION TYPE
    Molded and Angled
    Secure connection for all Power, Ground and Speaker connections. Angled for ease of access while creating a clean wire mangement profile
    FULL-RANGE RCA OUTPUTS FOR SIGNAL PASS THROUGH
    Output RCA connectors are for use with STRAPPING feature
    LED SYSTEM PROTECTION CIRCUITRY DIAGNOSTICS
    Monitor overload and speaker short protection with illuminated indicators on the amplifier end panel
    BASS REMOTE INCLUDED
    Wired Bass Remote allows adjustments to bass frequencies from the control which can be mounted anywhere in the vehicle.
    PHASE ADJUSTMENT
    Phase 0-180°
    Bass drum attack, snap requires phase between deep frequency subwoofers and upper midbass speakers
    Fat man/Skinny man, must arrive at your ear at the same time or bass sounds muddy
    STRAPPING
    Power Strapping allows the installer to Sync the input signal and output power to double the rated output of a mono amplifier which will drive a single subwoofer or group of subwoofers.
    Driving subwoofers with this method doubles the available power to the overall bass system, while insuring each subwoofer receives the exact same power level (output voltage)
    CONSULT PROFESSIONAL INSTALLER.
    Description CLASS Super D Class™ VARIABLE VOLTAGE 9V - 0.2V SIGNAL TO NOISE >95dB FREQUENCY RESPONSE 10Hz-50KHz CROSSOVER Variable  Electronic 35Hz - 250Hz BASS BOOST 0 - 10dB SUBSONIC FILTER 15Hz - 35Hz PHASE SHIFT 0-180° POWER @ 1 OHM 1 x 5000 POWER @ 2 OHMS 1 x 2500 Watts POWER @ 4 OHMS 1 x 1250 Watts MONO BRIDGED @ 4 OHMS N/A TOTAL CHANNELS 1 AUDIO INPUTS RCA AUDIO OUTPUTS 1 RCA Output  (Master) 1 RCA Input (Slave) STRAPPING Mode Switch MST/SLV POWER TERMINAL 12V/GND 0 AWG SPEAKER TERMINAL WIRE GAUGE 10 AWG FUSING External 275A <0.10% RCA INPUTS OPERATION MODE Mono only CROSSOVER TYPE ELECTRONIC EQUALIZER CLASS / TOPOLOGY OUTPUT DEVICE TECHNOLOGY HEAT SINK POWER SUPPLY Simpatico Coil Design  OUTPUT CONNECTIONS CONNECTION TYPE Molded and Angled BASS REMOTE INCLUDED PHASE ADJUSTMENT Phas